MODEL 3442RA1 Miniature
Averaging Axial Extensometers

With gauge lengths of 1 and 2 inches (25 and 50 mm) and measuring ranges of 0.050 and 0.100 inches (1.2 and
2.5 mm), the Model 3442RA1 was designed for applications where tensile or compressive strength tests on small rock, concrete and other small compression samples is desired.

Axial strain is measured on opposite sides of the test specimen and the output is an average of the two readings. The Model 3442RA1 is available in a variety of configurations for samples 2 inches (50 mm) or smaller in diameter. All are self-supporting on the specimen and mount very easily. The conical point contacts included with the extensometer are made from tungsten carbide. If desired, the two cut-outs can be independently configured, providing two readings. Epsilon has versions for use in oil to 20,000 psi at 400 °F (1360 bar at 200 °C). These units will fit in small inside diameter vessels. For large diameter specimens, we suggest one of the Model 3542RA averaging axial extensometers.

The Model 3442RA1 extensometers are strain gaged devices, making them compatible with any electronics designed for strain gaged transducers. Most often they are connected to a test machine controller. The signal conditioning electronics for the extensometer is typically included with the test machine controller or may often be added. In this case the extensometer is shipped with the proper connector and wiring to plug directly into the electronics. For systems lacking the required electronics, Epsilon can provide a variety of solutions, allowing the extensometer output to be connected to data acquisition boards, chart recorders or other equipment.

Features

• Full bridge, 350 ohm strain gaged design for compatibility with nearly any test system.
• High accuracy, averaging output or optional dual independent outputs.
• Standard units meet existing ASTM class B-1 requirements for accuracy. A calibration certificate is included. ISO 9513 class 0,5 calibrations are available upon request.
• Rugged, dual flexure design for strength and improved performance.
• Includes high quality foam lined case.
• Easy mounting, attaches with integral springs.
• Self-supporting on the specimen.
• Designed for smaller diameter specimens.

 

Model 3442RA Available Versions: ANY combination of gauge length, measuring ranges and temperature range listed below is available, except as noted. Test specimen diameter(s) must be specified at the time of order. Other configurations may be available with special order; please contact Epsilon to discuss your requirements.

  CERTIFIED

Specifications

Excitation: 5 to 10 VDC recommended, 12 VDC or VAC max.
Output: 2 to 4 mV/V, nominal, depending on model
Linearity: ≤0.20% of full scale measuring range, depending on model
Temperature Range: Standard (-ST) is -40 °C to +100 °C (-40 °F to 210 °F)
Cable: Integral, ultra-flexible cable, 8 ft (2.5 m) standard
Operating Force: <30 g typical per side

 

Options

• Dual, independent outputs
• Connectors to interface to nearly any brand test equipment

 

> Shunt Calibration